INFORMATION FOR FIXTURE DESIGN

The information on the this form will enable us to understand what exactly is your requirement, and how best we can improve the efficiency of your furnace by increasing the component to fixture weight ratio taking into consideration maximum life of the fixtures.
Please fill the form and submit it separately for different types of furnaces
Company Name: *
Contact Person: *
Type of Furnace : *	Normalizing
	Hardening & Tempering
	Annealing
	Sealed Quench
	Isoannealing
	Vacuum type
	CGC
Others (please specify)
Furnace Manufacturer: *
Loading of Furnace: *	Batch type
Loading of Furnace: *	Continuous
Heating chamber dimensions *	Length : mm
	Width : mm
	Height : mm
Maximum temperature for Heat Treatment *	oC.
Rated Furnace capacity: *	kg
Present capacity utilization:*	kg
Total weight of components :*	kg.
Weight of Fixtures *	kg.
Quenching Medium: *	Air
	Water
	Oil
	Polymer

If batch type furnace. Loading is by: *	Crane; Capacity kg.
If batch type furnace. Loading is by: *	Charger; Capacity kg.

Type of Fixture used:*	Basket
Type of Fixture used:*	Tray

Additional Components of Fixture: *	Fixture plates
	Pillars
	Spacers
	Side Plates
Others (please specify)
No. Of trays used per batch for:*	Batch Nos. Continuous Nos
Movement of trays in the furnace: *	On Rollers
Movement of trays in the furnace: *	On carbide bricks
Details of*	BASE TRAY
Details of*	BASKET
1. Maximum size*	Length : mm
	Width : mm
	Height : mm
2. Minimum allowable distance between two consecutive ribs*	mm
3. Maximum allowable distance between two consecutive ribs*	mm
4. If the tray moves on rollers, the distance between rollers*	mm
5. Maximum allowable load*	kg.
6. Present Grade of HRS used:*	HH H K HT HU HX MS SS304 SS310

7. Present Life:*	Months or Working hours
8. Expected Life:*	Months or Working hours
9. Failure Due to:
FIXTURES: Please send the Drawings/Sketches of the components to be heat-treated showing the major dimensions, their weight and the areas where the heat-treatment is critical. Also specify how the component is to be loaded. For e.g. if the component is shaft like, whether it is to be loaded vertically or horizontally or if it is a gear, whether it is to be placed horizontally or vertically.
SPECIAL INSTRUCTIONS :
Form filled by:*
	Email me a copy of this message

Address: SY. No.72/5, NAVAGE INDUSTRIAL AREA,
POST : NAVAGE, BELGAUM-590 018 INDIA
Phone: +91 7338697444, +91 9448146697
E-mail: kapeelfounders@yahoo.com
Mon-Sat 08:30 AM - 05:00 PM,